SKF P Series User Manual

4. Assembly instructions Page 17
EN
4. Assembly instructions
4.1. General information
Only qualified technical personnel may install,
operate, maintain, and repair the piston pumps
with/without lubricant reservoir described in the
owner’s manual. Qualified technical personnel are
persons who have been trained, assigned and
instructed by the operator of the final product into
which the described piston pumps with/without
lubricant reservoir are incorporated. Such persons
are familiar with the relevant standards, rules,
accident prevention regulations, and operating
conditions as a result of their training, experience,
and instruction. They are qualified to carry out the
required activities and in doing so recognize and
avoid potential hazards.
The definition of qualified personnel and the
prohibition against employing non-qualified
personnel are laid down in  DIN VDE 0105 and
IEC 364.
Before assembling/setting up the piston pumps
with/without lubricant reservoir, the packaging
material and any shipping braces (e.g., plugs) must
be removed. Keep the packaging material until any
discrepancies have been resolved.
Warning!
The product must not be tilted or dropped.
During all assembly work on machinery, observe the
local accident prevention regulations as well as the
applicable operating and maintenance specifications.
4.2. Setup and attachment
Piston pumps with/without lubricant reservoir
should be protected from humidity and vibration,
and should be mounted so that they are easily
accessible, allowing all further installation work to be
done without difficulty and allowing the piston
pumps to be filled easily.
Ensure that there is sufficient air circulation to
prevent excessive heating of the piston pump. For
the maximum permissible ambient temperature, see
 "Technical data."
For product-specific technical data, see the
relevant  documentation. If no
documentation is available, you can
request the documentation directly from
SKF Lubrication Systems Germany AG.
Consult the  technical documentation for the
mounting position.
The fill level in the lubricant reservoir and all other
visual indicators must be clearly visible.
Ensure sufficient clearance for operation of the hand
lever on manually operated piston pumps.
Drill the assembly holes for mounting the piston
pump as specified in the  technical
documentation.
If no documentation is available, the dimensions and
location of the fastening holes on the connecting
flange can be determined by taking measurements.
If no documentation is available, you can
request the documentation directly from
SKF Lubrication Systems Germany AG.

SKF P Series Specifications

General

Brand	SKF
Model	P Series
Category	Water Pump
Language	English