Skoda 2012 Superb - Connecting the mobile phone to the hands-free system

›
Voice control of the telephone » page 141.
›
Music playback from the telephone or other multimedia units » page 143.
All communication between a mobile phone and your vehicle's hands-free system
is established with the help of Bluetooth
®
technology. The adapter serves only
for charging the telephone and for transmitting the signal to the vehicle's exter-
nal aerial.
Note
The following guidelines must be observed » page 132, Mobile phones and two-
way radio systems.

Connecting the mobile phone to the hands-free system
To connect a mobile phone with the hands-free system, both of the devices have
to be interconnected. Detailed information on this is provided in the operating in-
structions for your mobile phone. The following steps must be carried out for the
connection:
›
Activate Bluetooth
®
and the visibility of your mobile phone on your telephone.
›
Switch on the ignition.
›
Select the menu Phone - New user in the information display and wait until the
control unit has completed the search.
›
Select your mobile phone from the menu of the units found.
›
Confirm the PIN
1)
.
›
If the hands-free system announces (as standard SKODA_BT) on the display of
the mobile phone, enter the PIN
1)
within 30 seconds and wait, until the connec-
tion is established
2)
.
›
After terminating the connection, confirm the creation of a new user profile in
the information display.
If there is no free space available to create a new user profile, delete an existing
user profile.
During the connecting procedure, no other mobile phone may be connected with
the hands-free system.
Up to four mobile phones can be paired with the hands-free system, whereby on-
ly one mobile phone can communicate with the hands-free system.
The visibility of the hands-free system is automatically switched off 3 minutes af-
ter the ignition is switched on and is also deactivated when the mobile phone has
connected to the hands-free system.
Restoring the visibility of the hands-free system
If you have not managed to connect your mobile phone with the hands-free sys-
tem within 3 minutes of switching on the ignition, the visibility of the hands-free
system can be reestablished for 3 minutes in the following ways.
›
By turning the ignition off and on.
›
By turning voice control off and on.
›
Via the information display in the menu point Bluetooth - Visibility.
Creating a connection with an already paired mobile phone
After switching on the ignition, the connection is automatically established for
the already paired mobile phone
2)
. Check on your mobile phone if the automatic
connection has been established.
Disconnecting the connection
›
By withdrawing the ignition key.
›
By disconnecting the hands-free system in the mobile phone.
›
By disconnecting the user in the information display in the menu Bluetooth -
User.
Solving connection problems
If the system announces No paired phone found, check the operating state of the
mobile phone.
›
Is the mobile phone switched on?
›
Is the PIN code entered?
›
Is Bluetooth
®
active?
›
Is the visibility of the mobile phone active?
›
Has the mobile phone already been paired with the hands-free system?
£
1)
Depending on the Bluetooth
®
version on the mobile phone, an automatically generated 6-digit PIN is
either displayed or the PIN 1234 has to be entered manually.
2)
Some mobile phones have a menu, in which the authorisation for establishing a Bluetooth
®
connec-
tion is completed by inputting a code. If the authorisation input is required, it must always be per-
formed when re-establishing the Bluetooth connection.
135
Communication