The interior monitor detects movements inside the car and then triggers the
alarm.
Switch off the interior monitor and towing protection monitoring
›
Switch off the ignition.
›
Open the driver door.
›
Press the button
on the centre column on the driver side » Fig. 14, the sym-
bol that lights up in the button changes from red to orange.
›
Lock the vehicle within 30 seconds.
The interior monitor and the towing protection monitoring are switched on again
automatically the next time the car is locked.
Note
■
Switch off the interior monitor and the towing protection monitoring if there is
a possibility of the alarm being triggered by movements from (e.g. children or ani-
mals) within the vehicle interior or if the vehicle has to be transported (e.g. by
train or ship) or towed.
■
The opened glasses storage compartment reduces the effectiveness of the in-
terior monitor. To ensure the full functionality of the interior monitor, the glasses
storage compartment must always be closed before locking the vehicle.
KESSY system
Introductory information
The KESSY system (Keyless Entry Start Exit System) enables a comfort unlocking
and locking of the vehicle and a start-up without actively using the remote con-
trol key. When unlocking and locking the vehicle or for starting the engine it suffi-
ces to carry the key with you, e.g. in your pocket.
The functions of the central locking system, safe securing system and anti-theft
alarm system correspond to vehicles without the KESSY system. Only the control
elements are different.
Control elements of the system:
›
Sensor on the outside of the door handle for the front door
1
» Fig. 15 - serves
for locking the vehicle,
›
Sensor on the inside of the door handle for the front door
2
» Fig. 15 - serves
for unlocking the vehicle.
Unlocking and locking car
Fig. 15 KESSY: Designation of the areas and unlocking/locking the vehicle
To lock/unlock a vehicle fitted with the KESSY system, it is necessary for the valid
remote control key to be located no more than around 1.5 m from the front door
handle or boot lid.
If a valid remote control key is located in the area
A
» Fig. 15 or
B
of the vehicle,
it is possible to unlock the vehicle via the relevant door of the area in which the
key is located. This means, if the key is located in the area
A
, the vehicle can be
unlocked from the handle on the front left door. If the valid key is located in the
area
C
, it is possible to unlock the boot lid.
Unlocking the vehicle
›
If you hold the door handle on the front door or cover the sensor
2
» Fig. 15
with the whole palm of your hand, the vehicle will unlock. If you cover the sen-
sor
2
at the same time as the sensor
1
when unlocking the vehicle, it is not
unlocked.
Locking the vehicle
›
Close the driver or front passenger door.
›
If you touch the sensor
1
with your fingers, the vehicle is locked (while doing
so do not hold the door handle, otherwise the vehicle cannot be locked).
›
On vehicles fitted with automatic gearbox, the selector lever must be moved in-
to the position P before unlocking.
Deactivating the safe securing system
›
Use your fingers to touch the sensor
1
twice within 2 seconds.
Unlocking and locking the boot lid
›
Press on the handle of the boot lid, and the lid is unlocked. If the vehicle is fit-
ted with the electric boot lid, the lid starts to open after pressing the handle.
£
38
Using the system
To Next Page
Loading...
