Safety pushbutton
The buttons for power windows in the rear doors can be deactivated by pressing
the safety pushbutton
S
» Fig. 25. The buttons for the power windows in rear
doors are activated again by pressing the safety pushbutton
S
again.
If the buttons for the rear doors are deactivated, the indicator light in the safe-
ty switch
S
lights up.
Button on the front passenger door and rear doors
Fig. 26
Arrangement of the button on
the rear door
First read and observe the introductory information and safety warn-
ings on page 46.
A button for the relevant window is provided in these doors.
Opening a window
›
A window is opened by pressing lightly on the respective button in the door.
The opening process stops when one releases the button.
›
Additionally, the window can be opened automatically (fully open) by pressing
the button to the stop. Renewed pressing of the button causes the window to
stop immediately.
Closing a window
›
A window is closed through pulling lightly on the respective button in the door.
The closing process stops when one releases the button.
›
Additionally, the window can be closed automatically (fully closed) by pulling
the button to the stop. Renewed pulling of the button causes the window to
stop immediately.
ä
Force limiter of the power windows
First read and observe the introductory information and safety warn-
ings on page 46.
The electrically operated power windows are fitted with a force limiter. It reduces
the risk of bruises or injuries when closing the windows.
If there is an obstacle, the closing process is stopped and the window goes down
by several centimetres.
If the obstacle prevents the window from being closed during the next 10 sec-
onds, the closing process is interrupted once again and the window goes down by
several centimetres.
If you attempt to close the window again within 10 seconds of the window being
moved down for the second time, even though the obstacle was not yet been re-
moved, the closing process is only stopped. During this time it is not possible to
automatically close the window. The force limiter is still switched on.
The force limiter is only switched off if you attempt to close the window again
within the next 10 seconds - the window will now close with full force!
If you wait longer than 10 seconds, the force limiter is switched on again.
Window convenience operation
First read and observe the introductory information and safety warn-
ings on page 46.
The electrically powered windows can be opened and closed as follows when un-
locking and locking the vehicle (only sliding/tilting roof or panoramic sliding roof
closed):
Opening a window
›
by holding the pressed unlock button on the remote control,
›
by pressing and holding the top part of the central locking button on the driver's
door.
Closing a window
›
by holding the pressed lock button on the remote control,
›
by pressing and holding the lower part of the central locking button on the driv-
er's door,
›
by holding the key in the driver's lock in the lock position » page 40,
›
on the KESSY system, by covering the sensor
2
» Fig. 15.
£
ä
ä
48
Using the system
To Next Page
Loading...
