Instrument lighting
Fig. 35
Dash panel: Instrument lighting
First read and observe the introductory information and safety warn-
ings on page 54.
›
Switch on the light.
›
Turn the control dial » Fig. 35 to the desired intensity of the instrument light-
ing.
The illumination intensity of the Information display » page 18 is set automatical-
ly. It is only possible to adjust the instrument lighting with the control dial if the
light intensity drops below the set value of the light sensor.
Headlamp beam adjustment
Fig. 36
Dash panel: Lights and Visibility
First read and observe the introductory information and safety warn-
ings on page 54.
›
Switch on the light.
›
Turn the control dial » Fig. 36 to the desired width of illumination.
ä
ä
Settings
The positions correspond approximately to the following vehicle loads:
Front seats occupied, luggage compartment empty.
All seats occupied, luggage compartment empty.
All seats occupied, luggage compartment laden.
Driver seat occupied, luggage compartment laden.
CAUTION
Always adjust the headlight range adjustment in such a way that:
■
it does not dazzle other road users, especially oncoming traffic,
■
and the range is sufficient for safe driving.
Note
The Bi-Xenon bulbs adapt automatically to the load and driving state of the vehi-
cle (e.g. speed, accelerating, braking) when the ignition is switched on and when
driving. Vehicles that are equipped with Bi-Xenon headlights do not have a man-
ual headlight range adjustment control.
Switches for the hazard warning light system
Fig. 37
Dash panel: Switch for hazard
warning lights
First read and observe the introductory information and safety warn-
ings on page 54.
›
Press switch » Fig. 37 to switch the hazard warning light system on or off.
£
-
1
2
3
ä
59
Lights and Visibility
To Next Page
Loading...
