10
Skydio 2/2+ - Operator Manual © 2021 Skydio, Inc. All rights reserved.
Return Behavior
Customize the way Skydio behaves after initiating a return:
Return Height - Allows you to set the height to which Skydio
should ascend before returning. By default, the Return
Height is set to 32 ft (9.7 m). Skydio will ascend to that height
before returning.
Height Behavior - Choose between Absolute and Relative
• Absolute means your drone will ascend to the specified
Return Height above the launch point before returning.
For example, if the Return Height is 32 ft and the drone is
at 20 ft at the time the return is commanded, Skydio will
ascend 12 ft before returning.
• Relative means your drone will ascend to the specified
Return Height above the current position before returning.
For example, if the Return Height is 32 ft and the drone is
at 20 ft at the time the return is commanded, Skydio will
ascend 32 ft and then return at a height of 52 ft.
Drone Looks - Skydio will either look toward or away from
the return destination while returning.
Return Speed - Adjust the speed at which Skydio should fly
when returning.
Lost Connection - Lets you choose how you want your
drone to behave if the signal to your controlling device is
lost:
• Wait Before Return - Specify the amount of time that
you want Skydio to wait before it initiates a return flight,
allowing time to reconnect.
• Land Once Returned - When enabled, Skydio will return,
hover for a specified amount of time, and then land.
• Wait Before Land - Specify the amount of time between
0 to 300 seconds (the default is 240 seconds) that you
want Skydio to wait before landing. This setting is only
enabled when Land Once Return is toggled on.
Drone Settings Menu
Pre-Flight
Lost Connection return settings
Return Behavior settings
To Next Page
Loading...
Need help?
General
