Page 38 December 2007
DC Electric Full-size RTs
Section 2 - Operation Start Operation
2.10-3 To Activate Platform Control Console
1. On battery roll-out tray, ensure battery connectors
are properly connected.
2. On base control console, select “
” platform
position.
3. Ensure base “
” emergency stop button is
pulled out.
WARNING
Ensure that you maintain three points of
contact when using the ladder to mount/
dismount platform.
4. Use the ladder of aerial platform to access
platform.
5. Close the gate.
6. On platform control console, insert key into
base/off/platform key switch and select “
”
platform position.
7. Ensure platform “
” emergency stop button is
pulled out.
2.10-4 To Raise or Lower Platform Using
Platform Control Console
WARNING
Be aware of overhead obstructions or
other possible hazards around the aerial
platform when lifting.
WARNING
Do not lower the platform unless the
area below is clear of personnel and
obstructions.
1. Activate platform control console (refer to
Section 2.10-3).
2. On platform control console, select lift/off/drive
switch to “
” lift position.
3. Activate and hold “
” enable trigger switch.
4. Move controller handle forward or backward until
desired height is reached.
NOTE
Lowering is not proportional.
5. Return controller to neutral center position to stop.
Release “
” enable trigger switch.
WARNING
To protect against unintended movement of
the aerial platform, push in the emergency
stop button after you have arrived at your
desired location or elevation.
NOTE
If the tilt alarm sounds and the platform does
not, or only partially raises, immediately
lower the platform completely and ensure
that the aerial platform is on a firm level
surface.
To Next Page
Loading...
