Page 42 December 2007
DC Electric Full-size RTs
Section 2 - Operation Start Operation
2.10-10 Electrical Inverter (If Equipped)
1. Ensure that battery connectors are properly
connected.
2. Make sure on/off switch of the inverter is on.
3. Inverter state is indicated by the LEDs on the face
of the inverter. A glowing green LED indicates
normal operation. If a fault occurs, the status LEDs
will indicate the area responsible.
CAUTION
The battery connectors must be properly
disconnected at the end of the shift or the
batteries will drain.
2.10-11 Shutdown Procedure
1. Completely lower the platform.
2. On platform control console, push in “
”
emergency stop button.
3. Select base/off/platform key switch to “ ” off
position and remove key from platform control
console.
WARNING
Ensure that you maintain three points of
contact when using the ladder to mount/
dismount platform.
4. Use the ladder to dismount from platform.
5. Disconnect battery connectors.
To Next Page
Loading...
Need help?
General
