DC Electric Full-size RTs
December 2007 Page 39
Start Operation Section 2 - Operation
2.10-5 To Drive Forward or Backward
WARNING
Be aware of blind spots when operating
the aerial platform.
WARNING
Ensure that there are no personnel
or obstructions in the path of travel,
including blind spots.
Activate platform control console (refer to 1.
Section 2.10-3).
On platform control console, select lift/off/drive 2.
switch to “
” drive position.
Activate and hold “3. ” enable trigger switch.
Push or pull controller handle forward or backward 4.
to desired speed and direction of platform
travel.
Return controller handle to neutral center position 5.
to stop. Release “ ” enable trigger switch.
WARNING
To protect against unintended movement of
the aerial platform, push in the emergency
stop button after you have arrived at your
desired location or elevation.
2.10-6 To Steer
1. Activate platform control console (refer to
Section 2.10-3).
2. Select lift/off/drive switch to “ ” drive position.
3. Activate and hold “ ” enable trigger switch.
4. Press “ ” rocker on top of controller handle in
either direction to steer.
NOTE
Steering is not proportional. Driving and
steering may be active at the same time.
To Next Page
Loading...
Need help?
General
