DC Electric Full-size RTs
December 2007 Page 45
Section 2 - Operation Loading/Unloading
Forklift pocket
Forklift pocket
NOTE
The mass of the aerial platform is as
per Table 2.3. The center of gravity is
approximately located in the middle of the
aerial platform, front to back and side to
side, as illustrated in Figure 2-17. Vertically,
the center of gravity is approximately just
above the base chassis.
NOTE
The aerial platform can be lifted with a
forklift from the sides but Skyjack does
not recommend this use. Lift with forks
in designated pockets as illustrated in
Figure 2-18.
2.11-2 Driving
Before driving the aerial platform:
Ramp or dock capacity must be sufficient to •
withstand maximum aerial platform weight.
Ramp should be equipped with side guards to •
prevent inadvertent fall from the ramp.
Incline must not exceed aerial platform gradeability •
(refer to Table 2.3).
Aerial platform brake must be checked for proper •
operation.
Aerial platform speed must be on high torque •
setting.
WARNING
When transporting, the aerial platform
must be secured to the truck or trailer
deck. Tie downs are available as illustrated
in Figure 2-16.
Figure 2-18. Forklift Pockets
To Next Page
Loading...
Need help?
General
