SJ63 AJ+ 213211AAA
67
Extend or retract the boom with the base control console Section 5 – Operation
5.7 Extend or retract the boom
with the base control
console
IMPORTANT
The maximum platform capacity changes with the
boom position. The indicator lights on the base
and platform control consoles show if the platform
is in the high or low capacity zone.
1. Move and hold the start/function enable/
emergency power switch to the function enable
position.
2. Move the boom extend/retract switch to the
extend or retract position. Release the switch to
stop.
5.8 Make the platform level
with the base control
console
1. Move and hold the start/function enable/
emergency power switch to the function enable
position.
2. Move the platform-leveling override switch to
the up or down position. Release the switch to
stop.
5.9 Operate with the
emergency power switch
at the base control
console
This switch enables all of the functions, with the
exception of drive, if there is an engine malfunction.
Refer to Section 6.1 for the emergency-lowering
procedure.
5.10 Energize the platform
control console
1. Turn the off/base/platform key switch to the
platform position.
WARNING
Fall hazard. Use the three points of contact
principle when you enter or exit the platform. If
you do not obey, there is a risk of death or serious
injury.
WARNING
Fall hazard. Do not operate the controls on the
platform control console without the correct fall-
protection attached to the designated location in
the platform. If you do not obey, there is a risk of
death or serious injury.
2. Enter the platform and close the gate or drop
bar.
3. Attach the body-harness lanyards of each
occupant to the fall-protection anchorage points.
The fall-protection anchorage points are rated
for one person per anchorage.
4. Pull the emergency-stop button on the platform
control console.
5. Select the start position from the engine start/
on/off switch until the engine starts.
IMPORTANT
The maximum platform capacity changes with the
boom position. The indicator lights on the base
and platform control consoles show if the platform
is in the high or low capacity zone.
To order go to Discount-Equipment.com
To Next Page
Loading...
Need help?
General
