Skyjack SJ9233 RT - 10 Platform Assembly

44
221491AAA SJ9233 RT, SJ9243 RT, SJ9253 RT
Section 4 – Inspections Before Operation Visual and daily maintenance inspections
4
1
2
2
2
2
5
3
4.2-10 Platform assembly
Do the inspection that follows in sequence:
WARNING
Fall Hazard. Use the three points of contact
principle when you use the MEWP ladder to enter
or exit the platform. If you do not obey, there is a
risk of death or serious injury.
1. Use the MEWP ladder to enter the platform.
2. Close the gate.
1
Platform railings
▪
Make sure there are no loose or missing parts,
and there is no visible damage.
▪
Make sure that the lock-pins and fasteners are
correctly locked.
▪
Make sure that the platform railings
1
are in
the correct position and locked with lock-pins.
▪
Make sure that the gate is in good condition
and operates correctly.
2
Fall-protection anchorages
▪
Make sure that the fall-protection anchorages
are correctly installed.
▪
Make sure there is no visible damage.
3
AC power socket
▪
Make sure that the socket is free of dirt or
blockages.
4
Platform control console
▪
Make sure that the control console is locked
with lock-pins.
▪
Make sure that the platform control cable
is correctly locked, and there is no visible
damage.
5
Manual storage box
▪
Make sure that the operation manual and
other important documents are in the manual
storage box.
▪
Make sure that the documents are in good
condition, and you can read them.
▪
Always put the manuals and other documents
back in the storage box after use.
3. Use the MEWP ladder to exit the platform.