71
SJ9233 RT, SJ9243 RT, SJ9253 RT 221491AAA
Use the platform control console from the ground Section 6 – Additional Procedures
4. Connect the platform control console cable to
the electrical connector at the rear side of the
MEWP.
5. Move the inclined-drive/level-drive switch to
the inclined-drive position.
6. Use as low a speed as practical to drive the
MEWP forward to the necessary location.
7. Push the emergency-stop button when the
MEWP is at the necessary location.
8. Turn the main power disconnect switch to the
off position.
WARNING
Fall Hazard. Use the three points of contact
principle when you use the MEWP ladder to enter
or exit the platform. If you do not obey, there is a
risk of death or serious injury.
9. Use the MEWP ladder to enter the platform.
CAUTION
Make sure each lock-pin is correctly installed with
the detent ball of each lock-pin fully through the
hole.
10. Install the platform control console onto the
mounting bracket. Install the lock-pin in the
mounting bracket.
11. Install the control cable into the railing clamp
and install the lock-pin.
WARNING
Fall Hazard. Use the three points of contact
principle when you use the MEWP ladder to enter
or exit the platform. If you do not obey, there is a
risk of death or serious injury.
12. Use the MEWP ladder to exit the platform.
13. Connect the platform control console cable to
the electrical connector below the platform.
To Next Page
Loading...
