Skyjack SJ9253 RT - Drive and Tie-Down the MEWP

75
SJ9233 RT, SJ9243 RT, SJ9253 RT 221491AAA
Move the MEWP for transport Section 6 – Additional Procedures
NOTE
For the weight of the MEWP, refer to
Section 7.3. Horizontally, the center of gravity
3
is approximately in the middle of the MEWP, front to
back and side to side. Refer to Figure 11. Vertically,
the center of gravity is approximately a small distance
above the chassis.
3
3
Figure 11 Approximate center of gravity
6.6-2 Drive and tie-down the MEWP
Before you drive the MEWP:
▪
The ramp or dock capacity must be able to hold
the maximum MEWP weight.
▪
Use side guards (if available) to prevent a fall
from the ramp.
▪
The incline of the ramp must not exceed the
MEWP gradeability. Refer to Section 7.3.
▪
Do a test of the MEWP brakes to make sure they
operate correctly.
▪
Move the inclined-drive/level-drive switch to the
inclined-drive (low speed/high torque) position.
WARNING
When you transport the MEWP, it must be attached
to a truck or trailer deck. Use the available
tie-down points
2
to attach the MEWP. Refer to
Figure 09 If you do not obey, there is a risk of death
or serious injury.
▪
Tie-down the MEWP to the transport vehicle
using the four tie-down points
2
. Refer to
Figure 09.