EasyManua.ls Logo

Skyleader 600 - Loss of Engine Power in Flight; In Flight Engine Restart; Engine Fire - on Ground; Engine Fire - in Flight

Skyleader 600
106 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- try to restart engine according to Art. 3.3.7
- if unsuccessful, perform an Emergency landing to terrain (according to Art. 3.3.2)
3.3.7. In ight engine restart
1. All unnecessary equipment - switch “OFF”
2. Continue according to Art. 4.2 Starting the engine
Be prepared for engine failure and Emergency landing to terrain (see Art. 3.3.2).
3.3.8. Engine re - on ground
1. Fuel cock- CLOSE
2. Brakes - use parking brake
3. Magneto A and B switches – switch “OFF”
4. Master switch - switch “OFF”
5. Heating - push in to CLOSE
6. Leave cockpit immediately and extinguish re (if it is possible)
Time necessary to deplete fuel from carburettor system is about 30 sec.
Do not attempt to restart the engine after extinguishing re!
3.3.9. Engine re - in ight
1. Fuel pump - switch “OFF”
2. Fuel cock - CLOSE
3. Throttle - OPEN (max. power)
4. Heating - push in to CLOSE
5. Magneto A and B switches (after fuel depletion and engine stop) – switch “OFF”
6. Maintain airspeed at 100-110 km/h (54-60kt)
7. If re continues, try side slipping. If this does not help, increase airspeed to the safe maximum in this situation.
8. Radio call - May Day, report your situation and location
9. Perform Emergency landing to terrain according to 3.3.2
10. After landing: Master switch - switch “OFF”
After extinguishing re, do not try to start up the engine again!

Table of Contents

Related product manuals