20. Toggle switches and avionics – switch “ON” - check
21. Trim - set neutral position
22. Trac pattern area - clear for entry to RWY
23. Report about to Lineup on RWY (radio call)
24. Release the brakes.
25. Lineup
4.7. Takeo
4.7.1. Normal takeo
1. RWY area – clear for takeo
2. Check time on clock. Report (Takeo radio call)
3. Brakes - released (make sure)
4. Throttle – OPEN (smoothly increase to takeo power)
5. Hold direction straight by rudder control
6. At speed 50 km/h (30 kt) smoothly p control stick back to lift front wheel. The aircraft will lift-o at 70 km/h (40
kt)
7. Levell o aircraft at 3 ft above the ground, until reaching 90 km/h (48 kt)
8. Climb at 110 km/h (60 kt) ; engine speed max. 5800 RPM (for max. 5 min)
9. Flaps retract at altitude 150 ft (50 m) AGL, than climb at 120 km/h (65kt) airspeed (at 5500 RPM)
10. Engine instruments – check values
11. EMS-display - check for any error messages
12. Trim – adjust as required to reduce control stick forces
4.7.2. Short eld takeo
1. RWY area – clear for takeo
2. Check time on clock. Report (Takeo radio call)
3. Brakes - use brakes
4. Throttle – OPEN (smoothly increase to takeo power)
5. Brakes - release brakes
6. Hold direction straight by rudder control
To Next Page
Loading...
