4.2. After entering cockpit
1. Emergency Parachute System handle - Check if it is locked
2. Adjust seat position, lock seat by locking mechanism
3. Canopy - Close and LOCK (Canopy lock LED doesn´t shine when canopy is closed and locked)
4. Seat belts – fasten and tighten
5. Head sets - put on head, adjust head band and microphone position
6. Control stick – free motion throughout its entire range of deection
7. Master switch – switch ”ON”
4.3. Starting the engine
1. Space behind the aircraft - Check if is clear (before starting the engine)
2. Throttle - CLOSE for cold engine (alternatively use choke) or 1/3 throttle for warm engine (do not use choke)
3. Fuel gauges – check fuel amount
4. Fuel cock – OPEN fuel tank with greater quantity of fuel
5. Nose wheel - hold in straight direction
6. Engine and ight instruments - check values
7. Propeller pitch - set MIN. angle
8. Fuel pump – switch “ON”
9. Magneto A switch – switch “ON”
10. Magneto B switch – switch “ON”
11. Brakes - use brakes or wheel chocks
12. Area around propeller – clear of obstructions, animals or people
13. Starter button - press until the engine starts up to run
14. Set engine speed after start up – 2000 RPM
15. Check oil and fuel pressures
16. Choke - deactivate as soon as the engine is running smoothly (if it has been used)
17. Engine instruments - check for any error messages
18. EMS - display - check for any error messages
19. Toggle switches and avionics – switch them “ON”
To Next Page
Loading...
