Mount conversely
- Before mounting lubricate inner sides of mounting bracket and outside upper and lower sides of shock absorber
ends with Cu 7439 plus
- Lightly tighten castle nut M8
- Secure with new split pins
Front undercarriage shock absorber disassembly and assembly3.5.
Disassembly
- Remove upper and lower ends of shock absorber; rubber springs and duralumin washers will be loosened
Check wear and tear of groove (not more than 0,4 mm (0.0157 in)) before mounting and surface of its opposing
spacing tube. Replace if grooves on surface are deeper than 0,2 mm (0.0079 in). Check rubber stopper in upper part
of chamber in piston rod.
To Next Page
Loading...