Procedures on holding point3.7.
Brakes – brake on1.
Engine speed – set idle2.
Controls – check free motion3.
Trim – in neutral position4.
Flaps – adjust take off position5.
Fuel – check quantity; open a fuel tank with suffi cient quantity 6.
(If is left fuel tank fi lled with more than ½ of fuel capacity, it is necessary to switch fuel cock to the left fuel tank.)
Fuel pump – switch on and check fuel pressure7.
Propeller – set a minimum angle for take-off (if it is adjustable)8.
Magnetos – check if both circles are switched on9.
Master – check if it is switched on10.
Engine instruments – check instrument values11.
Engine intake - set controller to fresh air (if it is mounted in the airplane)12.
Altimeter – set up13.
Safety belts – have to be fasten and tighten14.
Canopy –have to be closed and locked15.
Traffi c pattern area – clear for entry to RWY16.
Report17.
To Next Page
Loading...
