Assembly 2.4.3.
- Lay the wing next to the fuselage into a position convenient for the following assembly (it means the left one on
the left side and perpendicular to the fuselage and so on) and on a suitable pad
- Lubricate cleaned shaft joint and shaft coupler of fl ap control using BR 2plus
- Have wing bolts ready according to marking – do not replace one another!!!
- Remove sealings from additional fuel tank necks and fuel hoses.
- Grasp the wing at the wing root and on each the wing tip, and lift the wing root to the level of the center section
height
- Start inserting the pull-rod into the holes in the center section ribs by a careful movement of the wing towards the
fuselage
To Next Page
Loading...
