Maintenance Manual SL 200 Book 2
- Put the lower wing attachment point on the center section attachment point, put a screw in and secure it with
a washer and a M8 nut, then slightly tighten the nut
- Put lower fuel hose on the lower neck of additional fuel tank. Set the hose clip to have a screw accessible from
upper side of wing using long screwdriver.
- If you are assembling the right wing, connect the air pressure supply from the pitot tube with the air speed
indicator by sliding the hose endings in the hose coupling
- Keep lifting the wing tip slowly. Check the lower fuel hose. While lifting, put upper fuel hose on upper neck of
additional tank and connect the coupling with the fl ap control rod. Set the hose clip to have a screw accessible
from lower side of wing.
- Engage the upper and back attachment points on the wing and the center section.
- Put the screws in the attachment points (shorter screw goes to the back attachment point), and secure them with
a washer and a nut, then slightly tighten the M8 nuts.
- If additional tanks are installed, tight the screws on hoses.
- Move fl ap control lever to upper position in the cockpit. Connect the fl ap control using the bolt (4 mm (0.157 in)
diameter)
- Put a washer and a nut on the screw, tighten it and secure the nut with a new split pin. Drip oil + M55 plus on joint
bearing of the aileron control lever.
- Connect aileron control rod to aileron control lever using M5 bolt (head in fl ight direction), put the washer and nut,
tighten and secure the nut with a new split pin
- Tighten the nuts M8 on the attachment points fi rmly (9,5-22 Nm (7.01-16.23 lbf.ft) torque) and secure them with
split pins Put on covering strip (see B2-2.1)
- Install the covering metal sheets underneath out of the cockpit and install seats (see B2-2.3)
Attach the other wing to the center section in the same way.
To Next Page
Loading...
