Flight Manual SL 200 Book 1
Engine warm up and engine check3.5.
Brake the airplane (hand brake, chocks)1.
Set control stick and pedals in neutral position2.
Set propeller pitch to min. angle (if it is adjustable)3.
Engine speed - 2000 rpm and let run about 2 min., then warm up engine at 2500 rpm until oil temperature 4.
reaches 50C (122°F)
Stepless increase engine speed to maximum, hold about 5 sec. and than stepless reduce back to idle; repeat 2 or 5.
3 times
Check alternately both magnetos with engine speed 4000 rpm; engine speed should not descend more than 6.
300 rpm with one magneto off Diff erence between both magnetos should not exceed 120 rpm.
Procedures before taxiing3.6.
Unlock emergency parachute system – if it is installed1.
Release gyroscopes (attitude indicator, turn and bank indicator, gyro compass, etc.) (if installed)2.
Propeller pitch set to min. angle (if it is adjustable)3.
Retract fl aps4.
Report5.
Check brake function and range of directional control when taxiing6.
Adjust speed of taxiing to airfi eld surface condition and to direction and speed of the wind7.
To Next Page
Loading...