17
seconds until the tone level currently set appears. Operate on the -- symbol again to set the
desired level.
Command tones
It is possible to modify the type of sound emitted when operating on the commands.
In the STOP position, slightly press the + symbol for approx. 5 seconds. Operate on the +
symbol again to select “bt” (beep tone), “c” (click tone) or “nt” (no tone)
Energy saving
To limit the waste of electricity, the PS (Power Save) function can be used. This function
switches the oven off completely if, in absence of cooking functions activated, there is no
intervention with any command.
Press and hold the symbol for approx. 5 seconds, PS on will appear. The function is now
active and the oven will automatically turn off after approximately 1 minute. Operate on the
symbol to switch it back on.
Child safety
This function allows access to the functionality of the electronic programmer keys to be
blocked, both when the oven is running and when the oven is off.
By operating on the symbol for 2 seconds, this function is activated. This prevents
children or other persons from pressing the programmer keys involuntarily. thus modifying
the previous program or from starting the oven that is off.
Every programmer signal that intervenes while the oven is on, when the safety lock is
activated, can be eliminated by pressing any of the boxed keys. The safety lock will remain
active.
NOTES: The lock must be deactivated for access to a set program.
Error signals
When situations occur that prevent normal operation of the oven, the device informs this with
a series of signals, such as:
Err1: communication error – Err2: PT1000 (probe) open circuit – Err3: PT1000 (probe) closed
circuit – Err4: temperature too high on the display – Err5: temperature too high on the power
board – Err6: fault in the display – Err7: fault in the power board – Err8: no heating is
detected.
For the Err4 and Err5 errors, switch the oven off and allow it to cool for a few hours and then
try to use it again. If the error persists, call the technical after-sales assistance. If any of the
other errors are present, the authorised after-sales assistance must be informed.
To Next Page
Loading...