20
If the cooking mode is interrupted due to a power cut, the oven maintains all the information
regarding the cooking (blackout mode).
In fact, at the successive voltage restore, an intermittent acoustic signal will inform that the
oven has been blocked and the following wording will appear:
Once the oven system time has been set, the acoustic signal blocks and goes to PAUSE mode
(see reference paragraph).
Adjusting system time
The system time (clock) is based on the type of mains power supply (50Hz or 60Hz). Time
adjustment takes place with oven OFF:
Hold key 6 down for at least 3 seconds: the digits of the hour flash on the
display. Use keys 4 and 5 to set the value.
For the acquisition of the time set, it must be confirmed using key 6 .
Perform the same procedure to set the minutes.
If the oven is OFF, the control then shows just the system time, dimming after 1 min.
If the oven is in blackout mode due to a lack of voltage, the time digits already flash: operate
on keys 4 and 5 to set the time as specified above.
The oven is activated by pressing key 1 ON/OFF for at least 2 sec and switches off by
touching the same key.
If no keys are pressed after switch-on, the oven deactivates automatically after 1 min.
(accidental switch-on control).
Oven ON: single acoustic signal.
Oven OFF: double acoustic signal.
If the oven is off in low consumption mode (dimmed display light), at the first touch of a key,
we have RESUME mode. The low consumption mode is re-enabled automatically after one
minute.
ATTENTION: oven switch-off annuls all cooking programming and times set.
Accidental switch-on control
It is an automatic oven switch off signal. This takes place after oven switch on using key 1
ON/OFF and 1 min of commands inactivity, i.e. no function selected and activated. After 1
minute, a double acoustic signal will inform of switch-off.
Oven on: in stand-by for commands
By pressing key 1 ON/OFF the oven switches on while waiting to receive settings on the
desired cooking function.
Ventilated cooking is the default function (Circular Resistance + Radial Fan) with pre-set
temperature equal to 180°C.
The display is as per figure:
To Next Page
Loading...