APPENDIX A
CONFIGURING AND CALIBRATING YOUR SMARTBOARD E70 INTERACTIVE FLAT PANEL WITH WINDOWS
25 smarttech.com/kb/170534
To set Screen Mode
1. Press Menu on the remote or on the side panel.
The on-screen display menu appears.
2. Press the up and down buttons and select Setup.
3. Press the right button on the remote control or VOL- to select Screen Mode.
Select 16:9 if not already selected.
Setting up multiple displays
When you use your SMARTBoard E70 in a multiple display environment (that is, your computer has
an additional monitor or a built-in display), you must ensure that your display settings are
configured properly for your operating system.
Windows XP operating system
Ensure that:
l Your computer’s display is mirrored
OR
l The E70 is the primary display
Windows 7 or 8 operating system
To set up the SMARTBoard E70 as your touch screen:
NOTES
l Ensure the resolution has been set to recommend settings prior to calibration.
l Steps to calibration, first Setup then Calibrate (only calibrate if required).
a. Setup tells the system what device is a touch device and enables touch, test touch
device after Setup if touch is accurate the calibration step may not be required.
b. Calibration fine tunes touch points.
1. Open Control Panel > Tablet PC Settings. Ensure that the Display tab is visible. Ensure that
the Display tab is visible. Select SMARTE70 from the Display drop down menu.
To Next Page
Loading...
