SMART LightRaise - Page 25

SMART LightRaise Installation and User's Guide 17
NOTE:
If your installation is on a cinder block wall, try to drill the holes into the center of
as many blocks as possible.
Console Bracket
Tamper-Resistant Fastener Locations
Keyholes
Concrete Screws
Outer Holes
To mount the console bracket on a wall with wood studs:
1
Use the Phillips hand screwdriver to insert drywall anchors at the marked keyhole
locations.
2
Use the Phillips hand screwdriver to partially thread a #8 x 1¼" truss head screw into each
anchor console bracket, leaving ¼"
(6 mm)
of the screw exposed.
Truss Head Screw
Drywall Anchor
3
Hang the console bracket on these two screws, pushing the keyholes firmly down over the
protruding screws. Use the bubble level to confirm that the console bracket is level. This is
important because the mounting locations for the boom brackets are established from the
console bracket.
4
Use the pencil to mark the hole locations for the toggle bolt anchors.
Console Bracket
Keyholes
Toggle Bolt Anchor Locations
5
Remove the console bracket.
6
Drill a ¼"
(6 mm)
pilot hole and then the final ½"
(13 mm)
hole through the drywall at each
toggle bolt anchor location.
IMPORTANT:
Don't use a
hammer to
insert the
drywall
anchors.