SMART LightRaise - Page 36

28 SMART LightRaise Installation and User's Guide
2
Have your assistant support the boom as you attach the locking lever. For both sides of
the boom shaft, swing the locking lever over the pivot pin and insert a lock washer and a
#10-32 x
5
/
16
" Phillips screw into place.
Lock Washer
Phillips Screw
Pivot Pin
Locking Lever
3
Have your assistant raise the boom.
4
For each strut, slide the strut end into the slot on the lower boom bracket. Align the strut's
screw slots with the holes on the lower boom bracket. The strut end should lock into
position. Repeat for the other strut.
Boom
Final Position
Original Position
Upper Boom Bracket
Strut End
Lower Boom Bracket
5
For each strut, insert two #10-32 x
5
/
16
" Phillips screws to attach the strut end to the lower
boom bracket.
#10-32 / "
Phillips Screws
5
16
Strut End
Lower Boom Bracket