SMARTFOX Pro 2 - Settings: Analogue Output (Forced Release); Phase Control and Forced Engagement

SETTINGS - ANALOGUE OUTPUT
www.smartfox.at
T A N G E S S E R V I C
E S
s t a r t
0 0 : 0 0
l a n g e
1 0 0 m i n
l E I S T U N G
1 0 0 %
Select whether a 1-phase or 3-phase power controller is controlled. The setting
increases the accuracy of the analogue curve, but has no influence on the control
behaviour of the power controller.
Forced engagement
Here you can set the timed forced release for the analogue output in the event of
insufficient surplus energy in order to ensure hot water preparation without an
external source.
Enter the switch-on time for the daily forced release.
The daily duty cycle of the forced release.
Specifies how high the power controller should be controlled during forced release. In
most cases, a level of 100% is recommended.
27
L E A D I N G S T A T E S
1 - P H A S I
G