DISPLAY OF THE
MEASURED
VALUES
NOTE!
After connecting the power supply, the unit starts and
automatically
switches to
the
menu DISPLAY MEASUREMENTS.
B E C A U S E N E R G I E = 5
7 . 0 4 K W H
l i e v
e r n e r g i e s =
0 . 4 7 k w h
Performance and PNutz
POWER = 20W The current power is displayed. 20 Watt current consumption,
drawn from the mains. There is a return delivery to the mains when a minus value
is displayed, e.g. -20W.
PNUTZ= 500W. Currently, 500W is used via the analogue output (stepless). This is
a calculated value according to the setting of the nominal load and the
level of the
analogue output. As soon as ANALOG OVERV
is displayed
under PNUTZ,
analogue
monitoring is active. This means that the connected consumer is no longer
consuming power (e.g. thermostat of the heating element has switched off). After 5
minutes, the system checks again to see if the consumer is consuming power
again.
Energy
purchase
Purchased energy = The total energy purchased from the grid.
Energy
delivery
Delivery energy = The total energy fed back into the grid.
14
L e a s t = 2 0 w p n u
t z = 0 w
To Next Page
Loading...
Need help?
General