HGM6100N Series Genset Controller User Manual Page 23 of 47
Temp. Sensor Open
Circuit Action
0: Not used; 1: Warning; 2: Shutdown
Oil Pressure Sensor
Open Circuit Action
Disconnect Oil
Pressure Delay
When disconnect conditions include oil
pressure and engine oil pressure is higher
than disconnect oil pressure delay, the genset
is regarded as start successfully and starter
will disconnect.
Circulate condition: monthly, weekly and daily
can be selected.
Start time and duration can be set.
Circulate condition: monthly, weekly and daily
can be selected.
Don’t start time and duration can be set.
0 Not used; 1 Warn; 2 Shutdown
When power is higher than preset value and
duration exceeds than delay, over power
warning is active. Return and delay value can
be set.
0: Disabled; 1: Enabled.
Start interface delay can be set.
Enter password interface of maintenance
configuration.
Set the date/time of controller.
Flexible Sensor Curve
Type
0 User-defined temperature sensor
1 User-defined pressure sensor
2 User-defined level sensor
Choose sensor which need to be set, input
every point (8 points need to be input)
resistance and corresponding value(or
current, voltage) of curve.
NOTE: It is only
suitable for
HGM6100CAN.
0: Default Theme;
1: OEM Plant Theme; 2:
Terminal Users Theme
It is the time of the genset fuel output during
power on.