Programming Instructions for SRU Boards
Page 6 © 2019 Smartrise Engineering, Inc. All Rights Reserved May 9, 2019
USB*Debug*Adapter*
To program an SRU board you will need:
• Smartrise Programming Pod (USB Debug Adapter).
• A fully charged laptop with up to date software. An older version may experience
compatibility issues.
• The software for the specific job is provided by Smartrise in two ways:
• A Smartrise Flash drive is included in the job binder.
• By an online software link. Contact Smartrise if you do not have the software for the
particular jobsite.
Figure 4: USB Debug Adapter
Replace*a*Functioning*MR*SRU*Board*for*a*Newer*Revision*Without*
Losing*Settings*
Perform the following to replace a functioning MR SRU board without losing the settings.
Remove the CAT5 pigtail from the MR SRU NET.
NOTE: This is the communication cable that connects the MR SRU to the existing CT
SRU.
Figure 5: Remove CAT5 Pigtail
To Next Page
Loading...
