Programming Instructions for SRU Boards
Page 14 © 2019 Smartrise Engineering, Inc. All Rights Reserved May 9, 2019
Installing*the*Sm artrise*Progra mmer*
Special considerations need to be made when installing the software.
The following procedure describes how to install the Smartrise Programmer Application
Double click on (5) New Smartrise Programmer Folder in the software package. See
Figure 14.
Double click on 1 - Programmer Installer folder.
Figure 15: 1 - Programmer Installer Folder
Install the Smartrise Programmer.
Figure 16: Smartrise Programmer
Installing*the*Cont roller*Software *
Once the Smartrise Programmer software is installed, the controller software must be installed.
The following procedure describes how to install the controller software.
Once the Smartrise Programmer is installed, navigate back to the list of the software
package folders and double click on the (1) - Controller Software folder. See Figure 14.
Double click on the Controller Software folder, in this example the version is 2.20h. The
version will vary on the production date of the job.
Figure 17: Controller Software Folder
Double click on the JCF file. If it does not open, then the Smartrise Programmer might
not be correctly installed. See Installing the Smartrise Programmer
To Next Page
