SmartVent Lite+ User Manual

5
Confirm
MAN
operation
Go to
FAN SPEED
value
Select
FAN SPEED
value
Save all
settings
Go to
Home
Screen
Confirm
AUTO
operation
Select
TEMP
value
Go to
TEMP
value
Save all
settings
Go to
Home
Screen
Modes
Auto Operation and Temperature (TEMP) Setting
Your SmartVent Lite+ system can choose at what speed to draw air depending on the indoor and outdoor air
temperatures, when in AUTO. If the system is in either BOOST or RECYCLE modes, the fan will, instead, operate at
the speeds set for those particular modes.
You select the SET temperature you want it to be in the home (ie. 22°C (default)) and the system will work on the
best air source to achieve your SET temperature
1)
.
For example, if you set your system to 20°C while the current house temperature is 18.3°C, the control system
measures the incoming air temperature and alters the fan speed to suit. If the incoming air temperature is
20°C or higher, the fan will operate at a high speed to use the free heat to try and increase the overall house
temperature. If lower than 20°C, the fan speed would decrease to reduce the cooling effect
2)
.
- On the Home Screen, press SETTINGS
and then UP , or DOWN , to toggle to ON
- Press SELECT
to enter VENTILATION mode
- Press UP
, or DOWN
, to toggle to AUTO operation and follow the guide below to adjust the temperature
setting.
- Alternately, if already in ON and on the Home Screen, press SELECT
to toggle directly to AUTO operation
and follow the same guide below to adjust the temperature setting.
1) Your system is not a heating or cooling device. This parameter is designed to reduce nuisance over-heating or over-cooling of your home.
2) Additional features are available when low temperatures are present. See RECYCLE mode.
Manual (MAN) Operation and System Fan Speed and Air Source Settings
Your SmartVent Lite+ system allows manual control of the fan speed if required. Fan speed will remain constant
at the speed set. If the system is in either BOOST or RECYCLE modes, the fan will, instead, operate at the speeds
set for those particular modes.
- On the Home Screen, press SETTINGS
and then UP , or DOWN , to toggle to VENTILATION mode
- Press SELECT
to enter VENTILATION mode and then UP
, or DOWN
, to toggle to MAN operation and
follow the guide below to complete the setting of the system fan speed and the selection of the air source.
- Alternately, if already in ON and on the Home Screen, press SELECT
to toggle to MAN operation and
follow the same guide below to change the system fan speed.

SmartVent Lite+ Specifications

General

Brand	SmartVent
Model	Lite+
Category	Fan
Language	English