Configuring the Switch
3-6
• Frame Type – Either “Tagged” or “All.” “Tagged” means that the port will only send
and receive VLAN-tagged packets. When set to “All,” the port will also send and
receive untagged packets.
• PVID – The VLAN ID assigned to untagged frames received on the interface.
(Default: 1)
Trunk Information
• Trunk – The trunk label. “T1” through “T4” are used as trunk labels.
• Type – All trunks and ports on this switch are 10/100/1000Mbps
• Trunk Status – Indicates the speed and duplex setting of the trunk. This can be
changed on the TRUNKS > Settings page.
• 10hdx: 10 Mbps half duplex.
• 10fdx: 10 Mbps full duplex.
• 100hdx: 100 Mbps half duplex.
• 100fdx: 100 Mbps full duplex.
• 1000fdx: 1000 Mbps full duplex.
• Ports – The ports that are members of the trunk.
VLAN Information
• VLAN ID – A number in the range 1 - 4094 which identifies the VLAN.
• VLAN Member – A list of the ports that are members of the VLAN. By default, all
ports are members of VLAN 1.
To Next Page
Loading...
