SMC Networks PF2MC7 Series - Page 46

-45-
No.PF※※-OMZ0002
●Setting range of the accumulated flow output
The accumulated output setting range is displayed by the set value of the 4 digits and the units.
Set the value by key operation in the sub display. The upper 4 digits of the value is displayed by shifting
of the digit. Refer to the table below for details of the set value and display.
Accumulated minimum unit: 10 L Accumulated minimum unit: 1 L
Key
operation
Set
accumulated
value
Sub screen display
Key
operation
Set
accumulated
value
Sub screen display
Value
Units
indication
Value
Units
indication
△
0
0
L
△
0
0
L
↓
to
to
↓
to
to
1,000
1.000
x10
3
L
1.000
1.000
x10
3
L
to
to
to
to
9,990
9.990
x10
3
L
9.999
9.999
x10
3
L
to
to
to
to
•
99,990
99.99
x10
3
L
•
99.990
99.99
x10
3
L
•
to
to
•
to
to
•
1,000,000
1.000
x10
6
L
•
1.000.000
1.000
x10
6
L
to
to
to
to
10,000,000
10.00
x10
6
L
10.000.000
10.00
x10
6
L
to
to
to
to
99,990,000
99.99
x10
6
L
99.990.000
99.99
x10
6
L
↑
to
to
↑
to
to
▽
9,999,900,000
9999
x10
6
L
▽
9,999,000.000
9999
x10
6
L
∗: The units on the right side of the sub screen will flash.
Selection of display colour
The display colour (main screen) can be selected depending on the switch
output condition.
Press the SET button to set.
Return to function selection mode.
[F 1] Setting of OUT1 is completed.
∗1: Selected item becomes valid after pressing the SET button.
∗2: After enabling the setting by pressing the SET button, it is possible to return to the measurement mode by keeping pressing the
SET button for 2 seconds or longer.
∗3: If OUT2 output specification is not available, 2SoG and 2Sor will not be displayed.