錯誤! 尚未定義樣式。
18
SMC8014WN and SMC8014WN2 Wireless Cable Modem Gateway Administrator Manual
Figure 6. Connecting the Gateway to the a Laptop or Desktop Computer
Connecting the WAN
To connect the Gateway to a Wide Area Network (WAN) interface:
1. Connect a coaxial cable to the port labeled CATV on the rear panel of the Gateway from a
cable port in your home or office (see Figure 2 on page 6 or Figure 4 on page 14). Use
only manufactured coaxial patch cables with F-type connectors at both ends for all
connections.
2. Hand-tighten the connectors to secure the connection.
Powering on the Gateway
After making your LAN and WAN connections, use the following procedure to power on the
Gateway:
1. Connect the supplied power cord to the port on the rear panel of the Gateway (see Figure
2 on page 6 or Figure 4 on page 14).
2. Connect the other end of the power cord to a working power outlet. The Gateway powers
on automatically, the Power LED on the front panel goes ON, and the other front panel
LEDs show the Gateway’s status (see Table 1 on page 11 or Table 3 on page 13).
WARNING: Only use the power cord supplied with the Gateway. Using a different
power cord can damage the Gateway and void the warranty.
To Next Page
Loading...
Need help?
General
