錯誤! 尚未定義樣式。
58
SMC8014WN and SMC8014WN2 Wireless Cable Modem Gateway Administrator Manual
Access Control Menu
Path: Firewall > Access Control
The Access Control menu lets you enable access control to block traffic at the Gateway's
LAN interfaces from accessing the Internet.
Note: The Access Control submenu is not available in the menu bar if Enable
Firewall Module is disabled in the Security Settings (Firewall) menu (see page
57).
By default, the Gateway does not block attempts to access the LAN from the Internet. To
enable access control, check Enable Access Control if it is unchecked and click Apply.
When Access Control is enabled, you can define up to:
y 35 filters for traffic types not permitted from the LAN to the Internet.
y 35 predefined and customer-defined access rules for well-known services, or for other
services if you know the protocol and port number for the application.
A check box at the bottom of the menu lets you configure the Gateway to listen for or ignore
ping requests on the Gateway’s Internet WAN port.
Figure 33. Access Control Menu