W
EB
C
ONFIGURATION
5-7
Displays a number, the speed in Mbps, followed by either "fdx" for
full-duplex or "hdx" for half-duplex.
•Flow Control Status – Indicates whether flow control is enabled or
disabled.
• Autonegotiation – Shows if auto-negotiation is enabled or disabled.
• Frame Type – Either "Tagged" or "All". "Tagged" means that the port
will only send and receive VLAN-tagged packets. When set to "All", the
port will also send and receive untagged packets.
•PVID – VLAN ID assigned to untagged frames received on the
interface. (Default: 1)
Trunk Information
• Trunk – The trunk label. "T1" through "T8" are used as trunk labels.
•Type – All trunks and ports on this switch are 10/100/1000M
• Trunk Status – An indication of the speed and duplex setting of the
trunk. This is a number, the speed in Mbps, followed by either “Full” for
full-duplex or “Half” for half-duplex. This can be changed on the
TRUNKS > Settings page.
•Ports – The ports that are members of the trunk.
VLAN Inoformation
•VLAN ID – A number in the range 1 - 4094 which identifies the VLAN.
• VLAN Member – A list of the ports that are members of the VLAN.
By default, all ports are members of VLAN 1.
To Next Page
Loading...
Need help?
General
