W
EB
C
ONFIGURATION
5-35
• Static - Enable source IP filter with configured values in IP
Address and IP Mask fields.
• DHCP - The IP address for the device connected to this port will
be automatically assigned by DHCP server and only frames with
the assigned IP address are allowed to access the network. The IP
Address and IP Mask fields will be filled with the assigned IP
address and 255.255.255.255 individually by software.
• IP Address - Setup IP addresses to allow accessing. Frames with IP
address outside the allowed range will be dropped.
• IP Mask - Setup IP subnet mask to allow accessing for a subnet. If frame
with a specific IP address is allowed, the mask should be set to
255.255.255.255.
• DHCP Sever Allowed - Set if DHCP server is enabled or disabled on
this port. When DHCP Server Allowed is selected on a port, the port is
allowed to be linked to a DHCP server. This can prevent the access of
unwanted or unsolicited DHCP servers.
To Next Page
Loading...
