Introduction
1-5
G—Voltage Switch
Use this switch to select either 230VAC or 115VAC power input.
H—Auxiliary Outlet
Use this outlet to connect optional equipment.
J —Filter Bowl Water Drain Input
Water from filter bowl inlet port.
K—Gas Sample Exhaust [1] Outlet
Vehicle gas sample exit port from NO cell.
L —Optional Oil Temperature Probe Port
Use this connection for the optional temperature probe, optional
part number 6004-0407-04.
M—RPM Pickup Port
Use this connection for the grey RPM pickup.
N—Sample Gas Port
Connect the exhaust sample hose/probe to this inlet.
O—Water Outlet
Sample filter bowl water drain.
P—Calibration Gas Inlet
Use this inlet to supply calibration gas to the analyzer.
Q—Optional Lightpen ENTER Button Port
Use this connection for the single wire on lightpen harness.
R—Optional Lightpen Port
Lightpen connector, part number 7009E9321-97.
S—Clean Air Inlet Port
Has a charcoal filter installed to filter the ambient air going into the
gas bench for calibration.
T —RS 232 Port
For communication to an external data logging PC.
✓
Contact
Equiserv
for additional information.
U—Keyboard Port
Connection for the optional keyboard.
V—Service Key Port
Service connection is only used by a Service Representative.
To Next Page
Loading...