4-1
Maintenance
The
DGA 1000 Gas Analyzer
is a precision diagnostic instrument
that requires little maintenance. The maintenance and service
procedures presented in this chapter are those which the operator
can perform. All other services should be performed by an
authorized Service Representative.
This chapter contains Maintenance and Troubleshooting
information. Accessory Kit information, Maintenance Parts
information and a list of Options are found at the end of the
manual.
Maintenance Schedule
The following items require periodic maintenance:
•
Leak check (vacuum)
— Refer to
1– Leak Check Vacuum‚ page 4-4
for more
information.
✓
The Leak check is automatically initiated after warm-up if
the Daily Leak check in Settings of the System Info Menu
is set to ON. Settings can only be configured by a Service
Representative.
•
Leak check (gas)
— This is an alternative check. (
Not for U.S.A. use
.)
4
To Next Page
Loading...