Introduction
1-17
Standard Lead Connections
To Analyzer
1. Make sure the on/off switch (G) is set to off (O). See
Figure 1-9
.
2. Plug the power cord into the AC power source (F) on
the back panel of the analyzer. Plug the other end into
a standard 120VAC grounded electrical outlet. See
Figure 1-10
.
✓
Make sure the voltage switch (G), at the main input
receptacle of the analyzer, is set to the correct voltage
before connecting the analyzer to a power source.
Figure 1-9
: Front Panel
To Next Page
Loading...