1-18
Introduction
\
✓
An optional 12V power adapter, part number 2-2650, is
also available. This allows the analyzer to be powered by
a vehicle battery.
3. Insert the keyboard connector to the keyboard port (U).
4. Connect the exhaust sample probe to the sample gas
port (N).
5. Insert the RPM pickup lead into the RPM pickup
port (M).
6. Insert the optional oil temperature probe into the oil
temperature probe port (L).
Connecting to a Vehicle
1. Insert the exhaust gas probe into the vehicle tail pipe.
Make sure the sample probe is fully inserted.
2. Connect the RPM pickup as follows:
— Use the grey inductive pickup, part number
6004E9312-95, when a spark plug wire is available to
connect the clamp, preferably near the distributor.
✓
Tests may be performed without an RPM connection.
✓
An optional orange capacitive pickup, part number
6004E9313-19, is available when a spark plug wire is not
accessible. Connect it to an injector body (cylinder No.1),
to the outside of the insulation of an injector wire, or a
group of injector wires (max. three).
✓
Route the pickup lead clear of any moving parts.
Figure 1-10
: Back Panel
To Next Page
Loading...