1-20
Introduction
Start-up
1. Make lead connections to the analyzer and the vehicle.
Refer to
To Analyzer‚ page 1-17
and
Connecting to a
Vehicle‚ page 1-18
.
2. Turn the analyzer power switch on (I). The Start-up
Screen displays.
3. Allow the analyzer to perform Warm-Up, Auto zero
calibration and HC hang-up check. This takes about 2.5
minutes.
— When the unit starts up after a Standby period, it
performs the Auto zero calibration and HC hang-up
check.
— When the analyzer completes the warm-up cycle, it
enters in the operating mode and the gas
measurement page displays. When the exhaust
sample probe is installed, the measurement results of
the exhaust gases are shown on the Measurement
Screen
Figure 1-11
.
For more information on the Measurement Screen, refer to
Chapter 2–Analyzer Screen Display Features
.
Figure 1-11
: Measurement Screen
To Next Page
Loading...