Introduction
1-9
Toggle RPM/Oil Temp
Select with arrow keys, and press ENTER to switch between RPM
indication and oil temperature indication on the screen.
✓
When the NO Measurement option is not installed, both
RPM Measurement and Oil Temp are shown on the
screen.
Select Data Memory Buffers and Limits Sets
— Select with arrow keys, and press ENTER to select data
buffer 1 or 2 into which data may be stored when the
FREEZE/STORE button ( ) is pressed TWICE.
— When this is done, the number 1 and/or 2 appears in the
middle of the screen to show measurements are stored.
✓
If emission limits are activated, limit set 1 is active when
data buffer 1 is selected and limit set 2 is active when
data buffer 2 is selected. Measurements are continuously
compared with the limit values and indications are given
on the Measurement Screen as too high (
Ï
), too low (
Ð
)
or correct (
✔
).
Results
— Select with arrow keys, and press ENTER to look at
measurements results in data buffer 1 and 2. The left
column shows the results of data buffer 1, the right of data
buffer 2.
— Select with right arrow (
) on the bottom right of the
Results Screen to add customer information to the
measurements results and press to print the results or Esc
to exit without printing.
— Press the PRINT key on the front panel to print the results.
✓
On the Results Screen shown in
Figure 1-5
, results of
data buffer 1 or 2 can be deleted by selecting the correct
number and pressing ENTER. The program displays
“Clear data buffer(s)?”. Select Yes to clear the data of
buffer 1 or 2.
To Next Page
Loading...