Snap-On ControlTech CTLNK1R240 - Deleting a Preset; Preset Deletion Process

7. BATCH COUNT screen is displayed next. Value can be changed by pressing UP/DOWN buttons. Once desired
batch count value has been set, press ENTER button.
8. PSET target screen is displayed labeled with same PSET number.
Note: Pressing ENTER button while EXIT menu selection is highlighted will exit without editing
PSET.
Deleting a Preset
Delete PSET function allows user to remove stored presets from wrench.
1. From Preset screen to be deleted, press and hold UNITS button for 3 seconds.
2. CHANGE PRESET screen is displayed.
3. Highlight DELETE menu selection using UP/DOWN buttons and press ENTER button.
4. Target screen is displayed and deleted PSET is no longer available for selection.
Note: Pressing ENTER button while EXIT menu selection is highlighted will exit without deleting
PSET.
Note: When a PSET is deleted, all other stored PSET’s will retain their original PSET numbers.
When a new PSET is entered, it will be assigned first available PSET number in sequence.
00
100.0
FT-LB
CHANGE PRESET
DELETE
EDIT
EXIT
UNIT
button
held
Target Screen
UP/DOWN buttons
ENTER button
PSET 02 00
92°
Preset Angle Screen
CHANGE PRESET
DELETE
EDIT
EXIT
ENTER button
MAXIMUM ANGLE
94°
ENTER
button
UP/DOWN buttons
BATCH COUNT
4
ENTER
button
UP/DOWN buttons
CHANGE PRESET
DELETE
EDIT
EXIT
PSET 02 01of04
92°
UNIT
button
held
Preset Angle Screen
UP/DOWN buttons
ENTER button
PSET 02 04
90°
Preset Angle Screen
CHANGE PRESET
DELETE
EDIT
EXIT
ENTER
button
UP/DOWN buttons
TARGET ANGLE
92°
MINIMUM ANGLE
90°
UP/DOWN buttons
ENTER
button