Snap-On ControlTech CTLNK1R240 - Sleep Time and LCD Contrast Settings; Setting Sleep Time; Setting LCD Contrast

Setting Sleep Time
This function will allow user to set interval wrench enters power-down state following last
applied torque or button press.
1. From Settings menu, use UP/DOWN buttons to highlight SLEEP TIME selection then press
ENTER button.
2. SLEEP TIME screen is displayed.
3. Use UP/DOWN buttons to select sleep interval.
Selectable Intervals:
 2 MIN (factory default)
 5 MIN
 10 MIN
 30 MIN
 1 HR
 2 HR
 8 HR
4. Press ENTER button to accept selection and exit to Settings menu.
ENTER
button
SN: 0412500366
CAL: 2014/01/01
ISD: 2014/01/01
TCF: 14800
EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
ENTER
button
VER: 1.0
OVR CNT: 0
TQZ: -1539
ANZ: 8196
UP/DOWN buttons
EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
UP/DOWN buttons
ENTER
button
SLEEP TIME
2 MIN
EXIT
EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
ENTER
button
UP/DOWN buttons
SLEEP TIME
8 HR
EXIT