Job Mode
Job Mode function allows user to enable or disable wrench preset Job mode. When in Job mode, wrench
executes presets in order configured and automatically switches to next preset when batch count reaches zero.
Wrench is locked and Preset lock icon is displayed when Job mode is enabled.
Note: Password entry is required to enable Job Mode. When enabled, password entry is required to re-enter
Configure menu (refer to ControlTech™ Calibration manual for default password).
1. From Configure menu, use UP/DOWN buttons to highlight JOB MODE selection then press ENTER button.
2. Job Mode enable/disable screen is displayed.
3. Use UP/DOWN buttons to select ENABLE or DISABLE.
4. Press ENTER button to accept selection and exit to Configure menu.
Note: Text "JOB" is displayed between PSET number and batch count when enabled.
Calibration
Calibration menu is password protected. Refer to ControlTech™ Calibration manual.
Setting Date and Time
Set Date/Time function allows user to set real-time-clock date and time for time stamping data records,
recording last calibration date and notifying user of an expired calibration interval.
Note: When date and time is set for first time, In-Service date is also set and is used for calculating initial
calibration interval (see "Setting Calibration Interval" in Advanced Configuration section).
1. From Configure menu, use UP/DOWN buttons to highlight SET DATE/TIME selection then press ENTER
button.
2. SET DATE screen is displayed with year highlighted.
3. Use UP/DOWN buttons to set year then press ENTER button to highlight month.
4. Use UP/DOWN buttons to set month then press ENTER button to highlight day.
5. Use UP/DOWN buttons to set day then press ENTER button.
To Next Page
Loading...
Need help?
General
