Snap-On ControlTech CTLNK1R240 User Manual

 Battery Replacement
Note: When replacing batteries, real-time-clock will maintain date and time for 20 minutes.
Note: Turn End Cap clockwise to unscrew.
Replace 240 models with three "AAA" cells only.
Batteries should be installed in carrier prior to carrier installation into wrench.
Battery negative contacts should be oriented with carrier springs.
Replace all other models with three "AA" cells only.
Note: When Replace Battery screen is displayed wrench will no longer operate until batteries are
replaced. Only POWER button functions which immediately turns off wrench.
 Memory Indicators
DATA IN MEMORY
MEMORY FULL
MEMORY ERROR
Less than 1500 torque and angle records stored in memory.
1500 torque or angle records stored in memory. New records will
not be recorded until memory is cleared.
Memory read or write error.
UNSCREW END CAP
INSERT NEW CELLS
POSITIVE (+) END
INTO HANDLE FIRST
LOW BATTERY
100% BATTERY
LEVEL
50% BATTERY
LEVEL
LOW BATTERY
REPLACE BATTERY
REPLACE BATTERY

Snap-On ControlTech CTLNK1R240 Specifications

General

Brand	Snap-On
Model	ControlTech CTLNK1R240
Category	Power Tool
Language	English