65
Maintenance Battery Pack
1— microSD Card
2— micro USB Jack (USB power supply connection)
Figure 10-1 Features (top)
It is highly recommended to use the supplied USB power supply adapter to charge the battery.
Using a non-approved power supply adapter (max. 500mA charge rate output) may result in
insufficient charging.
4. Connect the USB cable to the USB power supply adapter.
5. Connect the USB power supply adapter, to a live AC power source.
i The battery pack will also charge when the USB cable is connected to a PC (using the power
supplied from the PCs USB connection).
The battery charge indicator LED is located on the front of the Thermal Imager above the
control buttons (Figure 10-2). A red LED is turned on to indicate the battery is being charged.
A green LED indicates the battery is fully charged.
1— Battery Level Icon
2— Battery Charge Indicator LED (Red-charging, Green-charged)
Figure 10-2
(Device on) A battery level icon is used to indicate the charge level of the battery, and when
the battery is being charged (Figure 10-2).
To Next Page
Loading...